Dryer parts should meet the quality requirements, are not allowed into the design does not provide for gaskets and cover other parts. Spindle assembly dryer before assembly applications kerosene to clean the internal parts. Dryer spindle bearings should fill the right amount of the 2nd or the 3rd lithium grease to ensure proper lubrication. Grease should be sealed, it can not leak. Geometric accuracy of the dryer should be consistent idling noise provisions in Table 3 of the dryer must not exceed 78dB (A). Dryer rails, bearings and other drive components should be cleaned inside, without iron, sand and other foreign matter. Paint dryer may not have wrinkles, bubbles, flow marks, flaking and cracks and other defects. When the dryer bed being connected to the upper and lower portions, no obvious dislocation. Exposed bolt heads and fixing pins should be arranged in neat rows. Signs and markings on the dryer should correct eye-catching. 5 Test methods and test gauge shell weight, dryers should be type, basic parameters, geometric precision inspection and empty running test factory. Each dryer shall be subject to quality control department before leaving the factory after passing the test. The factory of the dryer should be accompanied by proof of product qualification documents. Test types and basic parameters: Information from Henan Acer offer you reprint Description Note: hnhjzsx